WPS drill rig on a riverside work platform at sunset, reflected in the water beside a rock-armoured bank, with safety fencing and a treeline behind

Proudly Albertan · Proudly Canadian

Foundations built for Alberta ground

Piling and shoring for heavy clay, deep frost, muskeg and minus-thirty mornings. We drill, screw and shore from Calgary to Fort McMurray — season after season.

  • Screw · Drilled · Micropiles
  • Soldier pile · Secant walls · Tiebacks
  • Calgary · Edmonton · Province-wide
  • Safety on every shift

    Hazard assessments before work starts and utility locates before every hole.

  • Engineered

    Every install follows a design by a licensed professional engineer, built on your geotech report and loads.

  • Province-wide

    From the Peace Country to the Crowsnest Pass, we mobilize where you build.

  • ACSA member
  • COR certified
  • ISNetworld® Member Contractor

What we do

Every foundation system Alberta ground demands

From screw piles under an equipment pad in Red Deer to a shored downtown excavation in Edmonton, we match the system to your soil, loads, access and schedule — then install it to design.

A Piling

03 systems

01 — Piling

Screw & helical piles

Torque-monitored steel screw piles for light commercial buildings, additions, equipment pads, signage and pipe racks. Load-ready the day they go in — no curing, minimal spoil, installable through winter.

  • Light commercial · industrial
  • Year-round install
  • Torque-verified

02 — Piling

Drilled cast-in-place piles

Straight-shaft and belled concrete piles drilled to design depth, with rebar cages and concrete placed to spec — the workhorse foundation for Alberta clay.

  • Straight-shaft & belled
  • Rebar cage placement
  • Temporary casing

03 — Piling

Micropiles

Small-diameter, high-capacity piles for restricted access, low headroom, underpinning and retrofit work where big rigs can't go.

  • Low headroom
  • Underpinning
  • Retrofits
Full-length rebar cage hanging beside the mast of a WPS drill rig, ready to set into a drilled pile inside a fenced work zone
Setting a rebar cage for a drilled pile

B Shoring & earth retention

03 systems
Illustration of a soldier pile and timber lagging shoring wall holding back a deep excavation in downtown Edmonton, with the High Level Bridge and river valley beyondIllustrative image

04 — Shoring

Soldier pile & lagging

Steel soldier piles with timber lagging to hold back excavations on tight urban lots, with walers, rakers or tiebacks as the design calls for.

  • Urban excavations
  • Walers & rakers
  • Temporary or permanent

05 — Shoring

Secant & tangent pile walls

Interlocking or touching concrete piles forming a stiff retaining wall where groundwater or neighbouring foundations demand it.

  • Groundwater control
  • Stiff retention
  • Adjacent structures

06 — Shoring

Tiebacks & ground anchors

Drilled, grouted and proof-loaded anchors that tie shoring back into the ground and keep the excavation clear of rakers.

  • Proof-loaded
  • Clear excavations
  • Permanent or temporary

On site

On the ground in Alberta

Our rigs at work: cage lifts at river crossings, steel casing and concrete going in, and drilling inside fenced, signed work zones.

  • Crawler crane lifting a rebar cage beside a WPS drill rig on a riverbank, with yellow silt booms and a life ring at the water's edge
    Cage lift at a river crossing
  • WPS drill rig beside a full-length rebar cage, with concrete mixer trucks waiting outside the fenced exclusion zone
    Rebar cage up, concrete on standby
  • WPS drill rig lifting a long steel casing into position, with a Hard Hat Area sign on the safety fence behind
    Steel casing going vertical
  • WPS drill rig against an orange sunset, with traffic cones and safety fencing around its work area
    Last light on the rig
  • WPS drill rig on a riverbank, with erosion-control matting laid over the slope and a life ring by the water
    Erosion-control matting down along the river
  • WPS drill rig inside a fenced work zone with a Hard Hat Area sign, cones and concrete barriers under a clear blue sky
    Fenced and signed before we drill

Who we build for

Foundations for Alberta’s heavy work

Downtown towers, river crossings and industrial plants. When the loads are big and the ground is difficult, we put the foundation under it.

  • WPS drill rig with its auger raised beside a steel casing, inside a fenced work zone with an Authorized Personnel Only sign

    01

    Commercial & mixed-use

    Mid-rise, retail and office foundations on tight downtown and infill sites, where schedule certainty matters.

  • WPS drill rig and crawler crane lifting a rebar cage on a riverbank, with yellow silt booms in the water and a life ring at the water's edge

    02

    Bridges & water crossings

    Drilled foundations and micropiles for bridges and crossings over Alberta's rivers and creeks.

  • Illustration of steel pipe piles staged for an industrial site in the boreal forest of northern AlbertaIllustrative image

    03

    Industrial & energy

    Screw piles and drilled foundations for plants, module yards, tanks and camps across northern Alberta.

How we work

From geotech to handover

Every job starts with the ground. Clear steps, documented as we go, so you always know where your foundation stands.

  1. Review

    Send drawings, loads and your geotechnical report. We review the ground, access and schedule with you.

  2. Design & plan

    Our own engineering team can design your pile or shoring system, or work with your engineers to refine their design for cost savings. We confirm layout and capacities and book utility locates through Click Before You Dig.

  3. Mobilize & install

    Our crews set up, drill or screw to design — logging every pile as it goes in.

  4. Test & verify

    Torque records, drilling logs or load tests as specified, so every pile's capacity is documented.

  5. Hand over

    As-built pile logs and documentation delivered so your next trade can start on schedule.

Commitment to safety

Safety is how we work, every day

On every Alberta job site, the day starts the same way: the crew walks the ground, talks through the hazards and plans the work before a rig moves. It’s how we look after our people, your site and everyone working around us.

WPS drill rig holding a steel pile casing upright inside a fenced exclusion zone, with a Hard Hat Area sign, traffic cones and concrete barriers
  • Hazard assessments

    A field-level hazard assessment before work starts, reviewed with the crew and updated as site conditions change.

  • Locates before we dig

    Utility locates booked through Click Before You Dig and confirmed on site before we drill or install a pile.

  • The right PPE

    Hard hats, hi-vis, safety boots, gloves, and eye and hearing protection on every worker, every shift.

  • Trained operators

    Rigs and support equipment run by trained, competent operators who know their machine and the ground.

Certified & verified

03 credentials
  • Alberta Construction Safety Association (ACSA) logo: WPS is a proud ACSA member (opens in a new tab)

    Proud member

    Alberta Construction Safety Association

    We belong to ACSA, the industry body that trains crews and certifies COR for Alberta’s builders.

  • COR Certificate of Recognition workplace safety seal: WPS holds an Alberta COR (opens in a new tab)

    Certified

    Certificate of Recognition (COR)

    Our health and safety system is audited and certified to Alberta’s government-endorsed COR standard, with ACSA as the certifying partner.

  • ISNetworld Member Contractor badge: WPS is an ISNetworld Member Contractor (opens in a new tab)

    Member contractor

    ISNetworld® Member Contractor

    Our safety and compliance information is on the ISNetworld® platform, ready for owners and general contractors who prequalify through ISN.

Logos are the property of their respective organizations. ISN® and ISNetworld® are registered trademarks of ISN Software Corporation.

Pink wild roses, Alberta's provincial flower, in front of rolling foothills, aspen groves and a winding river at golden hour, with the snow-capped Rocky Mountains beyond
Wild roses in the Alberta foothills · where the prairie meets the Rockies

Proudly Albertan · Proudly Canadian

Built here.
Built for here.

Alberta is home. The prairie skies, the foothills, the Rockies on the horizon every morning. We love this province, and we take real pride in building the foundations its communities stand on.

We know its ground, too: the heavy clays under Calgary and Edmonton, frost that heaves shallow footings, muskeg in the north and the river valleys in between.

From the Peace Country to the Crowsnest Pass.

WPS drill rig with temporary casing at dusk, behind safety fencing and cones, with trees glowing against a pink and orange sky

Ready when you are

Tell us what you’re building in Alberta

Send the location, drawings and geotech report if you have them. We’ll come back with the right foundation system, a schedule and a clear quote.